he product is applied to motorcycles, motorbikes, snowmobiles, personal watercrafts and household motor equipment, lawnmowers, chain saws etc. Due to its by 20% greater* active agent’s concentration, Extreme Action 120% (EX120) Revitalizant possesses extended potential of worn surface restoration and antiwear protection.
* compared to XADO MOTO.
ADVANTAGES
- Restores worn surface of engine cylinders, eliminates micro cracks and scratches
- Increases and levels compression in cylinders
- Protects friction surfaces against wear
- Reduces fuel consumption considerably
- Restores engine capacity up to factory values
- Increases service life of an engine by 3 times
- Decreases the level of toxic components in exhaust gases
- Decreases noise and vibration level.
APPLICATION
It is recommended preliminary to dissolve the content of the syringe in a small amount of oil (20-30ml) at its temperature of exceeding +25°C.
Instructions for engines with combined lubricating system:
- Introduce the content of the syringe into the petrol tank before fueling
- Fill the tank with fuel
- Start the engine and let it idle for 2-3 min
- Operate the engine in normal mode.
Instructions for engines with separate lubricating system:
- Warm up the engine to the normal operating temperature
- Empty the contents of the syringe into the oil filler neck
- Start the engine and let it idle for 2-3 min
- Operate the engine in normal mode.
NOTE
- The compound is equally effective for application to two- and four-stroke internal combustion engines of all brands
- Does not influence the wet clutch operation
- It is not recommended to change oil in four-stroke internal combustion engines until the end of treatment
- The treatment is considered complete after not less than 1,500 km of run (approx. 20 hours of engine operation)
- If the engine capacity exceeds 1000 cm3 it is necessary to double the dosage
- The revitalizant is compatible with any additives, metal conditioners, remetalizants irrespectively of its application sequence
- Protective ceramic-metal coating is formed on the metal surface of any alloys. If the wear rate is close to 100%, the destroyed part are subject to replacement.