APPLICATIONINSTRUCTIONS
1. Warm up the engine. The engine should be warmed butnot hot.
2. Unscrew the plugs (burners).Disconnect the wire of the ignition timing sensor, Hall sensor or commutator.
3. Introduce the content of 1 tube into each cylinder through the plug hole.Screw the plugs back in. Wait for 10–20 minutes. Unscrew the plugs. Cover theplugholes with absorbing fabric to avoid flying-out dirt getting onto thepaint. Rotate the engine with a starter for several seconds.
4. Put the plugs (burners) back intoposition. 
5. Start the engine and let it work on the increased rotation frequency of acrankshaft for 15-20 minutes. During this time, the residues of the softenedcarbon will be removed through the exhausts system. 
DOSAGE
1 tube - 1 cylinder.
Note 
• Avoid getting the substance onto lacquer coating.
• Safe for catalytic neutralizers, oxygen sensors, mechanical rubber goods andsealings.
The VERYLUBE Anticarbon in tubes can be used for engine oil system flushing :
1. Introduce Anticarbon into the warmed-up engine through the oil-filler neckat a ratio 40 ml of Anticarbon for 3–5 liters of oil.
2. Let the engine idle for 10–15 minutes. 
3. Change oil and oil filter.

Package: 
10 ml – tube